Share what you did today with the Jeep Trackhawk community!

Example: Picked up the Havoc X today, can't wait to take it for a run.

Example: Installed CV guards, took a while but glad I got it done.

Example: Went for a drive at the trails!


Anything goes!

I stared at my havoc x Wondering if my havoc x will ever get repaired less than 100 miles and p0101 code pops up top speed 26 mph ,selling dealer closed its doors now, next dealer 1 hour away is to busy to see if he has diagnostic plug to diagnose problem been waiting over 2 weeks for that answer no word as to when they will look at it .repair manual has incorrect pin out for ecm,but i did get to make another payment yesterday on my machine that cost over 21,000 $ with little or no customer support!

Man that's a huge bummer. Can't believe your dealer just closed and left you high and dry with the new vehicle. Have you tried reaching out to head office to see if they can get you looked after. Is your Havoc even driveable at the moment?

yeh its drivable 26 mph is about tops .i mainly now just use it when wife walks dog at night for extra lighting and to move some rocks around at lower speed its fine idling ,good low end power there is nothing past 4500 rpms i do not think its speed limit issue on cluster ,but i do suspect bad cluster ,talked to articat yesterday they say they will extend warranty but did not follow up with me since i talked on this subject with them July 1st they assumed the next dealer had fixed my problem and left me waiting to call back pissed.i will call again today as their tech rep did not call back yesterday as promised.

Had t seen anyone post here for a while and thought I’d share this. The stock seats do get more comfortable after putting some miles on them, but could still be better. I found a set of 2018 Wildcat XX seats and modified them a little for my Havoc X. Turned out rather nice. Certainly more comfortable. What do y’all think?

Attached Thumbnails

         

 

Bath Time today!

Cadydid. They look great. Are they comfortable? I ride in the Adirondacks NY with many other riders all having either Polaris Generals,RZRs, rangers, articat wildcats, Kawasaki mules, treyx, Yamaha Vikings and Honda pioneers. I also driven them all. And none of the compare to the Havoc. The biggest complaint that I and all the other riders have is the seat positioning. Hopefully the 2019 havoc bench seat are a better fit for the machine. And if so they can replace the 2018 seats.

I'd be so pissed!!! Hope they get you fixed up brother.

yeh i was, i had found next closest dealer they did ecm and eps reflash i am back to working it and having fun been 3 months now no issues other than phantom cracking noise from frame or suspension i will look into i after wash down and next lift inspection.still did not add a park brake yet still pondering a roll control solenoid thoughts.being first time side x side owner it did exceed my expectations on power, hauling load of bed, trailer pulling, jumping, climbing and speed.

Nazz26, yes they are more comfortable. Textron should have done this to begin with. From what I hear, the bench seat from the 2019 should be able to go in the 2018, but I didn’t want bench seats, I like the buckets. My wife didn’t mind the stock buckets, but these are much better. They sell aftermarket seats, but I also didn’t want to spend $850+ on seats. I’ve got a total of $350 and some of my time modifying things in these seats. Personally think it turned out great. ��

By the way, the 2014 Wildcat X seats are like these too and some of them are green/black. Wish I’d found a set of those first, but still happy. Lol